DMM is bringing an old favourite back to the

These

• DMM's accurate heat treatment process optimises the physical property of the alloy to maximise bite.
• We've
• recessed the top of the nut and countersunk all other drilled radiuses
• in order to avoid stress points where the wire enters the nut. This
• also totally protects the wire from abrasion damage.
• The nuts are all rumbled well to remove sharp edges that can hinder placement
• The wire used on each nut is chosen so that the nut can be placed at full reach without them flopping around.
• We use a full size crimp because this is critical to safety
• The
• label is upside down so you can check the size easily when they are on
• your harness. The label is double sealed so that it does not tear with
• time and use.

(The image shows pre-production samples without the recessed wires or lightening holes).

Comments: